Main Harness

1. Disarm SRS as described under Technician Safety Information.
2. Remove lower cover and lower cover panel, then disconnect air bag connector at harness spool. Do not connect this connector again until main harness is securely installed.
3. Remove console panel and base on driver seat side.
4. Disconnect 12-pin yellow electrical connector from air bag control unit, then body harness connector B58 from connector AB1.
5. Roll up floor mat and remove lefthand side sill lower cover.
6. Remove main harness from clip and protector.
7. Reverse procedure to install. After completing installation, arm SRS as described under Technician Safety Information.