With Generic Scan Tool

CLEAR MEMORY MODE
SUBARU SELECT MONITOR (NORMAL MODE)
1) On the [Main Menu] display screen, select the (2. Each System Check} and press the [YES] key.
2) On the [System Selection Menu] display screen, select the {EGI/EMPi} and press the [YES] key.
3) Press the [YES] key after displayed the information of engine type.
4) On the [EGI/EMPI Diagnosis] display screen, select the (3. Clear Memory) and press the [YES] key.
5) When the 'Done' and 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru select monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

SUBARU SELECT MONITOR (OBD MODE)
1) On the [Main Menu] display screen, select the (2. Each System Check) and press the [YES] key.
2) On the [System Selection Menu] display screen, select the (EGI/EMPi) and press the [YES] key.
3) Press the [YES] key after displayed the information of engine type.
4) On the [EGI/EMPI Diagnosis] display screen, select the (7. OBD System) and press the [YES] key.
5) On the [OBD Menu] display screen, select the (4. Diagnosis Code(s) Cleared) and press the [YES] key.
6) When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7) Turn Subaru select monitor and ignition switch to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.