Oil Pressure Sender: Service and Repair

REMOVAL
1) Remove alternator from bracket.





1) Disconnect connector and terminal from generator.





2) Remove V-belt cover.
3) Loosen lock bolt and slider bolt, and remove front side V-belt.





4) Remove bolts which install generator on bracket.





2) Disconnect terminal from oil pressure switch.





3) Remove oil pressure switch.

INSTALLATION





1) Apply fluid packing to oil pressure switch threads before installation.

Fluid packing: THREE BOND 1215 or equivalent





2) Install oil pressure switch onto engine block.

Tightening torque: 25 ± 3 Nm (2.5 ± 0.3 kg-m, 18.1 ± 2.2 ft. lbs.)





3) Connect terminal of oil pressure switch.





4) Install generator on bracket and temporary tighten installing bolts.
5) Install front side V-belt and adjust it.





6) Install V-belt cover.





7) Connect connector and terminal to generator.