Differential Assembly: Description and Operation

IDENTIFICATION











When replacing a rear differential assembly, select the correct one according to the table.

CAUTION: Using the different rear differential assembly causes the drive line and tires to "drag" or emit abnormal noise when AWD is selected.


REAR DIFFERENTIAL





A: VA-Type (2200 CC AT Vehicles)
A hypoid drive gear with a nominal diameter of 152 mm (5.98 inch) is used and the drive pinion shaft is supported on three bearings, the bearing preload being adjusted by a selective spacer and washer. The drive pinion height is adjusted by selecting washers located at the drive pinion neck using Dummy Shaft and Gauge.





B: T-Type (EXCEPT 2200 CC AT Vehicles)
A hypoid drive gear with a nominal diameter of 160 mm (6.30 inch) is used and the drive pinion shaft is supported on three bearings, the bearing preload being adjusted by a selective spacer and washer. The drive pinion height is adjusted by selecting washers located at the drive pinion neck using Dummy Shaft and Gauge.