Torque Specifications

TORQUE SPECIFICATIONS

Cylinder Block Components












Cylinder Block Assembly




CAUTION: Remove oil the mating surface of bearing and cylinder block before Installation. Also apply a coat of engine oil to crankshaft pins.

1. Position crankshaft on the #2 and #4 cylinder block.





2. Apply fluid packing to the mating surface of #1 and #3 cylinder block, and position it on #2 and #4 cylinder block.
Fluid packing: THREE BOND 1215 or equivalent

CAUTION: Do not allow fluid packing to jut into O-ring grooves, oil passages, bearing grooves, etc.





3. Temporarily tighten 10 mm cylinder block connecting bolts in alphabetical sequence shown in figure.
4. Tighten 10 mm cylinder block connecting bolts in alphabetical sequence.

Tightening torque: 47 ± 3 Nm (4.8 ± 0.3 kg-cm, 34.7 ± 2.2 ft. lbs.)





5. Tighten 8 mm and 6 mm cylinder block connecting bolts in alphabetical sequence shown in figure.

Tightening torque:
(A) - (G): 25 ± 2 Nm (2.5 ± 0.2 kg-cm, 18.1 ± 1.4 ft. lbs.)
(H): 6.4 Nm (0.65 kg-cm, 4.7 ft. lbs.)