Replacement

REMOVAL
1. ACCELERATOR PEDAL
1. Disconnect ground cable from battery.
2. Disconnect accelerator cable from throttle body.

CAUTION: Be careful not to kink accelerator cable.

3. Remove instrument panel lower cover from instrument panel, and connector.





4. Disconnect accelerator cable from accelerator pedal lever.





5. Working inside engine compartment, remove casing cap out of the toe board by turning it clockwise.
6. Pull out the cable from the toe board hole.





7. Remove accelerator pedal connecting bolt from accelerator pedal bracket.

INSPECTION
2. ACCELERATOR PEDAL
Clean and apply grease to spacer and inside bore of accelerator pedal. Install accelerator pedal onto pedal bracket.

INSTALLATION





1. Installation is in the reverse order of removal procedures.

CAUTION:
^ Be careful not to bend clutch cable too much.
^ Never fail to cover outer cable end with boot.
^ Be careful not to kink accelerator cable.
^ Make sure that holder and casing cap are securely connected.

2. Adjust clutch pedal
3. Adjustment after pedal installation.