Disassembly and Reassembly

DISASSEMBLY
1. Remove the three screws securing upper C lower steering column covers, and the two screws. securing combination switch, then remove related parts.

INSPECTION
1. Basic Inspection





Clean the disassembled parts with a cloth, and check for wear, damage, or any other faults. If necessary, repair or replace faulty parts.

2. Airbag Model Inspection

WARNING: For airbag model inspection procedures, refer to Supplemental Restraint System.


ASSEMBLY
1. Insert combination switch to upper column shaft, and install lower column cover with tilt lever held in the lowered position. Then route ignition key harness and combination switch harness between column cover mounting bosses.
2. Fit upper column cover to lower column cover, and tighten combination switch and column cover.

Tightening torque: 1.2 ± 0.2 Nm (0.12 ± 0.02 kg-m, 0.9 ± 0.1 ft. lbs.)

CAUTION: Don't overtorque screw.