Cruise Control Servo: Service and Repair

REMOVAL AND INSTALLATION




1. Remove air intake chamber.




2. Remove air intake chamber stay.
3. Remove clip bands from cruise control cable.




4. Remove cruise control cable end from throttle cam.




5. Disconnect cruise control vacuum hose from intake manifold.
6. Remove actuator attaching bolts.




7. Disconnect connector from actuator, then remove the actuator.
8. Installation is in the reverse order of removal.

Tightening torque: 7.4 ± 2.0 Nm (0.75 ± 0.2 kg.m, 5.4 ± 1.4 ft.lb)

CAUTION: When inserting vacuum hose to intake manifold, apply sealant to the fitting hose.

Fluid packing: THREE BOND 1105 or equivalent

CAUTION:
- Be careful not to apply excessive load to the wire cable when adjusting and/or installing; otherwise, the actuator may be deformed or damaged.
- Do not bend cable sharply with a radius less than 100 mm (3.94 in); otherwise, cable may bend permanently, resulting in poor performance.
- When installing cable, be careful not to sharply bend or pinch the inner cable; otherwise, the cable may break.