Installation

1. While a helper holds fuel tank, push fuel tank harness into access hole with grommet.
2. Set fuel tank, and temporary tighten bolts in order to install fuel tank bands.




3. Connect fuel filler hose, and tighten clamp.
4. Connect fuel hoses, and hold then with clips and quick connector.




5. Tighten band mounting bolts.

Tightening torque:
33 ± 10 Nm (3.4 ± 1.0 kg.m, 25 ± 7 ft.lb)




6. Install rear crossmember.




7. Install rear differential assembly.




8. Connect connector to drain valve.
9. Connect connector to pressure control solenoid valve.




10. Connect hose to joint pipe.




11. Connect evaporation hose to canister, and hold them with clamp.




12. Connect hoses to roll over valve.




13. Install bolts which hold parking brake holding bracket.




14. Install heat sealed cover.




15. Install muffler assembly.




16. Install rear exhaust pipe.




17. Lower the vehicle.
18. Connect connectors to fuel tank harness, and plug access hole with grommet.




19. Install rear seat cushion. (Sedan model).




20. Set rear seat cushion. (Wagon model).




21. Install fuel filler cap.
22. Connect connector to fuel pump relay.




23. Connect battery ground cable.