Cruise Control Switch: Service and Repair

CRUISE CONTROL MAIN SWITCH




1. Remove screws and clip from instrument panel lower cover.
2. Remove panel lower cover.




3. Disconnect connector from cruise control main switch.




4. Remove main switch by pushing it outward.
5. Installation is in the reverse order of removal.

CRUISE CONTROL COMMAND SWITCH

CAUTION: Before starting operation carefully read the notes given in Air Bag Systems for proper handling of the airbag module.

1. Set front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect battery ground cable from battery and wait for at least 20 seconds before starting work.




4. Using TORX© BIT T30 (Tamper resistant type), remove two TORX© bolts which secure driver's airbag module.
5. Disconnect airbag module connector on back of airbag module.




6. Remove horn switch from steering wheel as shown.




7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.
8. Installation is in the reverse order of removal.