4. Control Valve and Oil Pan

4. Control Valve And Oil Pan





1. Install and route the transmission harness.

Caution: Be careful not to damage the harness.

2. Install the control valve assembly.
1. Set the select lever in range "N".





2. Temporarily tighten the valve body on the transmission case.

Caution: Be sure to engage the manual valve with the manual plate during installation.





3. Adjust the clearance between the manual valve and manual plate in the 0.1 to 0.9 mm (0.004 to 0.035 inch) range.
4. Tighten the valve body to the specified torque.
Tightening torque: 8 ± 1 Nm (0.8 ± 0.1 kg-m 5.8 ± 0.7 ft. lbs.)





3. Connect all connectors.
4. Install the oil pan.





1. Attach the magnet at the specified position.





2. Apply proper amount of liquid gasket (THREE BOND Part No. 1217B) to the entire oil





3. Install the oil pan to the transmission case assembly, and secure with 20 bolts.

Note: Tighten the bolts evenly.

Tightening torque: 4.9 ± 0.5 Nm (0.50 ± 0.05 kg-m, 3.6 ± 0.4 ft. lbs.)





5. Install torque converter turbine speed sensor and vehicle speed sensor 2 (front).
Tightening torque: 7 ± 1 Nm (0. 7 ± 0.1 kg-m, 5.1 ± 0.7 ft. lbs.)