Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.

After eliminating problem as per trouble code, clear memory as follows:





1. Make sure ignition switch is ON (and engine off). Connect one DIAG. terminal "A" on diagnosis connector terminal No.1.
While warning light is flashing, contact the other DIAG. terminal "B" on terminal No.2 for at least three seconds.

2. After memory is cleared, normal warning light flashing rate resumes. (Warning light flashes every 0.6 seconds ON-OFF operation.) Memory can not be cleared if any problem exists.

3. After clearing memory and then DIAG. terminals "A" and "B", extract from diagnosis connector.