Control Valve and Oil Pan

CONTROL VALVE AND OIL PAN





1. Install and route the transmission harness.

CAUTION: Be careful not to damage the harness.

2. Install the control valve assembly.
1. Set the select lever in range "N".





2. Install the control valve by engaging the manual valve and manual lever, then tighten the 17 bolts.

CAUTION: Tighten the control valve mounting bolts evenly.

Tightening torque: 8 ± 1 Nm (0.8 ± 0.1 kg-m, 5.8 ± 0.7 ft. lbs.)





3. Connect all connectors.
4. Install the oil pan.





1. Attach the magnet at the specified position.





2. Apply proper amount of liquid gasket (THREE BOND Part No. 1217B) to the entire oil pan mating surface.





3. Install the oil pan to the transmission case assembly, and secure with 20 bolts.

NOTE: Tighten the bolts evenly.

Tightening torque: 4.9 ± 0.5 Nm (0.50 ± 0.05 kg-m, 3.6 ± 0.4 ft. lbs.)





5. Install torque converter turbine speed sensor and vehicle speed sensor 2 (front).
Tightening torque: 7 ± 1 Nm (0.7 ± 0.1 kg-m, 5.1 ± 0.7 ft. lbs.)