Disassembly
1. Disconnect engine ground terminal from intake manifold.
2. Disconnect connector from ignition coil and ignitor assembly.
3. Remove ignition coil and ignitor assembly.
4. Disconnect connector from intake air temperature and pressure sensor.
5. Remove intake air temperature and pressure sensor from intake manifold.
6. Disconnect connectors from throttle position sensor and idle air control solenoid valve.
7. Disconnect air by-pass hose from throttle body.
8. Remove throttle body.
9. Disconnect connector from air assist injector solenoid valve.
10. Disconnect air by-pass hoses from air assist solenoid valve.
11. Remove air assist injector solenoid valve from intake manifold.
12. Disconnect pressure regulator vacuum hose from intake manifold.
13. Disconnect connectors from fuel injectors.
14. Disconnect connector from purge control solenoid valve.
15. Disconnect air by-pass hose from purge control solenoid valve.
16. Remove harness bands (*) which hold engine harness onto intake manifold.
17. Remove engine harness from intake manifold.
18. Remove purge control solenoid valve.
19. Remove bolt which installs injector pipe on intake manifold as shown in figure.
20. Remove bolt which installs injector pipe on intake manifold.
21. Remove two bolts which hold fuel pipes on the left side of intake manifold.
22. Remove bolt which installs injector pipe on intake manifold.
23. Remove fuel injectors.
1. Remove fuel injector securing clip.
2. Remove fuel injector while lifting up fuel injector pipe.
24. Disconnect air by-pass hoses from intake manifold.
25. Loosen clamp which holds front left side fuel hose to injector pipe and remove the pipe from clamp.
26. Loosen clamp which holds front right side fuel hose to injector pipe and remove the pipe from clamp.
27. Remove fuel injector pipe.
28. Remove bolt which installs fuel pipes on intake manifold.
29. Remove fuel pipe assembly and pressure regulator, from intake manifold.