Installation

1. Install intake manifold onto cylinder heads.

CAUTION: Always use new gaskets.

Tightening torque:
25 ± 2 N.m (2.5 ± 0.2 kg.m, 18.1 ± 1.4 ft.lb)




2. Connect fuel hoses.




3. Connect connector to camshaft position sensor.




4. Connect connector to oil pressure switch.




5. Connect connector to crankshaft position sensor.




6. Connect knock sensor connector.




7. Connect connectors to engine coolant temperature sensor.




8. Install air cleaner case stay RH and engine harness bracket, and connect engine harness connectors to bulkhead connectors.




9. Connect brake booster hose.




10. Connect engine coolant hose to throttle body.




11. Connect PCV hose to intake manifold.




12. Connect spark plug cords to spark plugs.
13. Install power steering pump on bracket.




1. Install power steering pump on bracket, and tighten bolts.

Tightening torque:
20.1 ± 2.5 N.m (2.05 ± 0.25 kg.m, 14.8 ± 1.8 ft.lb)




2. Install power steering pipe brackets on the right side of intake manifold.




3. Install power steering pump drive V-belt.
4. Adjust V-belt.




5. Install V-belt covers.




6. Install resonator chamber.

Tightening torque:
33 ± 10 N.m (3.4 ± 1.0 kg.m, 25 ± 7 ft.lb)

14.Connect accelerator cable (A).




15. Connect cruise control cable (B).(With cruise control models)




16. Install air intake duct and air cleaner assembly.




17. Connect connector to fuel pump relay.




18. Install fuel filler cap.




19. Connect battery ground cable.