Torque Converter Clutch Case and Transmission Case

Torque Converter Clutch Case and Transmission Case





1. Wrap the axle shaft serration with vinyl tape.
2. Remove the differential side retainer with ST.

CAUTION: Hold the differential case assembly by hand to avoid damaging retainer mounting hole of the torque converter clutch case and speedometer gears.

ST 499787000 WRENCH ASSY





3. Extract the axle shaft with ST1 and ST2.

CAUTION: Do not reuse the circlip.

ST1 499095500 REMOVER
ST2 499247300 INSTALLER





4. Remove the differential case assembly.

CAUTION:
- Remove the seal pipe if it is attached. (Reusing is not allowed.)
- Be careful not to damage the retainer mounting hole of the torque converter clutch case and the speedometer gears.