Brake Lamp: Service and Repair
REAR COMBINATION LIGHT1. Remove rear quarter upper and lower trim.
2. Remove nuts and disconnect connector.
3. Attach adhesive cloth tape to body area around rear combination light.
4. Using a standard screwdriver, carefully pry rear combination light off and away from the front of vehicle.
5. Installation is in the reverse order of removal.
Tightening torque:
4.4 ± 1.5 N.m (0.45 ± 0.15 kg.m, 3.3 ± 1.1 ft.lb)
CAUTION:
- Do not pry rear combination light forcefully as this may scratch vehicle body.
- Remove all traces of adhesive tape from body before installation.
- Attach butyl rubber tape to back of rear combination light before installing rear combination light on body for sealing purposes.