Coolant: Service and Repair
REPLACEMENT
1. REPLACEMENT OF COOLANT
WARNING: The radiator is of the pressurized type. Do not attempt to open the radiator cap immediately after the engine has been stopped.
1. Lift up the vehicle.
2. Remove undercover.
3. Fit vinyle tube to drain pipe.
4. Place a container under vinyle tube.
5. Loosen drain cock to drain engine coolant into container.
6. For quick draining, open radiator cap.
CAUTION: Be careful not to spill coolant on the floor.
7. Drain coolant from reservoir tank.
8. Tighten radiator drain plug securely after draining coolant. (Drain tube may face downward.)
9. Fill engine coolant into radiator up to filler neck position.
10. Fill engine coolant into reservoir tank up to "FULL" level. Coolant capacity (fill up to "FULL"level)
Approx. 6.0 l (6.3 US qt, 5.3 Imp qt)
CAUTION: The SUBARU Genuine Coolant containing anti-freeze and anti-rust agents is especially made for SUBARU engine, which has an aluminum crankcase. Always use SUBARU Genuine Coolant, since other coolant may cause corrosion.
11. Securely install radiator cap and reservoir tank cap.
12. Run engine for more than five minutes at 2,000 to 3,000 rpm. (Run engine until radiator becomes hot in order to purge air trapped in cooling system.)
13. Stop engine and wait until coolant temperature lowers. Then open radiator cap to check coolant level and add coolant up to radiator filler neck. Next, add coolant into reservoir tank up to "FULL" level.
14. Securely install radiator and reservoir tank caps.
2. RELATIONSHIP OF SUBARU COOLANT CONCENTRATION AND FREEZING TEMPERATURE
The concentration and safe operating temperature of the SUBARU coolant is shown in the diagram. Measuring the temperature and specific gravity of the coolant will provide this information.
[Example]
If the coolant temperature is 25 °C (77 °F) and its specific gravity is 1.054, the concentration is 35% (point A), the safe operating temperature is -14 °C (7 °F) (point B), and the freezing temperature is -20 °C (-4 °F) (point C).
3. PROCEDURE TO ADJUST THE CONCENTRATION OF THE COOLANT
To adjust the concentration of the coolant according to temperature, find the proper fluid concentration in the above diagram and replace the necessary amount of coolant with an undiluted solution of SUBARU genuine coolant (concentration 50).
The amount of coolant that should be replaced can be determined using the diagram.
[Example]
Assume that the coolant concentration must be increased from 25% to 40%. Find point A, where the 25% line of coolant concentration intersects with the 40% curve of the necessary coolant concentration, and read the scale on the vertical axis of the graph at height A. The quantity of coolant to be drained is 2.1 liters (2.2 US qt, 1.8 Imp qt). Drain 2.1 liters (2.2 US qt, 1.8 Imp qt) of coolant from the cooling system and add 2.1 liters (2.2 US qt, 1.8 Imp qt) of the undiluted solution of SUBARU coolant.
If a coolant concentration of 50% is needed, drain all the coolant and refill with the undiluted solution only.