Radiator Hose: Service and Repair
Water PipeA: REMOVAL
WARNING: The radiator is pressurized. Wait until engine cools down before working on the radiator.
1. Perform fuel pressure release. Refer to Powertrain Management.
2. Disconnect ground cable from the battery.
3. Drain engine coolant completely.
4. Remove intake manifold.
5. Disconnect heater inlet hose.
6. Disconnect radiator inlet hose from water pipe.
7. Remove bolts which install water pipe on cylinder block.
B: INSTALLATION
1. Install water pipe on cylinder block.
Tightening torque: 6.4 ± 0.5 Nm (0.65 ± 0.05 kg-m, 4.7 ± 0.4 ft. lbs.)
CAUTION: Use a new O-ring.
2. Connect radiator inlet hose.
3. Connect heater inlet hose.
4. install intake manifold.
5. Connect connector to fuel pump relay.
6. Connect ground cable to battery.
7. Lift-up the vehicle.
8. Install under cover.
9. Lower the vehicle.
10. Fill coolant.