Installation

Installation is in the reverse order of removal.
1. Connect quick connector on fuel delivery line.




CAUTION:
- Always use a new retainer.
- Make sure that the connected portion is not damaged or has dust.If necessary, clean seal surface of pipe.

1. Set new retainer (B) to connector (A).
2. Push pipe into connector completely.




NOTE: At this time, two clicking sounds are heard.




CAUTION:
- Pull the connector to ensure it is connected securely.
- Ensure the two retainer pawls are engaged in their mating positions in the connector.
- Be sure to inspect hoses and their connections for any leakage of fuel.

2. Connect fuel delivery hose to pipe in engine compartment with an overlap of 20 to 25 mm (0.79 to 0.98 in).




Type A: When fitting length is specified.
Type B: When fitting length is not specified.

l: 1.0 - 4.0 mm (0.039 - 0.157 in)
L: 20 - 25 mm (0.79 - 0.98 in)




3. Connect return hose and evaporation hose to pipe by approx. 15 mm (0.59 in) from hose end.

Fuel return hose:
L = 20 - 25 mm (0.79 - 0.98 in)

Fuel evaporation hose:
L = 15 - 20 mm (0.59 - 0.79 in)

CAUTION: Be sure to inspect hoses and their connections for any leakage of fuel.




4. Connect connector to fuel pump relay.