Brake Lamp: Service and Repair
REAR COMBINATION LIGHT1. Remove rear trim.
2. Remove nuts and disconnect connector.
3. Attach adhesive cloth tape to body area around rear combination light.
4. Using a standard screwdriver, carefully pry rear combination light off and away from the front of vehicle.
5. Installation is in the reverse order of removal.
Tightening torque:
4.4 ± 1.5 N.m (0.45 ± 0.15kg.m, 3.3 ± 1.1 ft.lb)
CAUTION:
- Do not pry rear combination light forcefully as this may scratch vehicle body.
- Remove all traces of adhesive tape from body before installation.
- Attach butyl rubber tape to back of rear combination light before installing rear combination light on body for sealing purposes.