Removal
1. SUNROOF PANEL1. Open sunroof approx. 1/3.
2. Remove clips attached to front side of sunroof trim by pulling trim from inside of compartment.
3. Move trim forward, and detach trim end from holder.
4. Detach trim.
5. Close sunroof and remove nuts.
6. Remove sunroof panel.
7. Installation is in the reverse order of removal.
NOTE: Sunroof trim reference pin must be fitted in holder notch.
2. SUNROOF MOTOR AND RELAY
1. Remove roof trim, rear quarter trim, pillar trim, etc.
2. Remove screw.
3. Disconnect connector.
4. Remove relay by pulling it out.
3. SUNROOF FRAME
1. Remove roof trim, rear quarter trim, pillar trim, etc.
2. Remove sunroof panel.
3. Disconnect front and rear drain tubes.
4. Disconnect connector between body harness and sunroof harness.
5. Loosen two mounting bolts near motor. (Do not remove bolts.)
6. Remove six bolts, and four adjusting nuts.
7. Remove sunroof frame.
8. Loosen set bracket mounting bolt.