Rear Seat

REMOVAL




1. Remove bolts securing hinges (located at front of seat) to body.
2. Pull strap (located in middle rear portion of cushion) to release lock. Lift cushion out and away from body.
3. Pull knobs (located at each side of backrest's upper portion) up to release lock, and fold backrest all the way forward.
4. Remove the bolt and then remove backrest (LH side).




5. Remove the bolt and then remove backrest (RH side) from hinge bracket.

INSTALLATION

1. Install hinge bracket to body.
2. Insert right backrest hinge pin into hole in bracket. Tilt backrest backward until striker engages with lock.




3. Secure right backrest center hinge to body using a bolt.
4. Temporarily install left backrest side hinge to body using a bolt, and fold backrest forward to the floor.
5. Roll up mat (located at rear of left backrest), and install center hinge using a bolt.
6. Tilt left backrest until striker engages with lock, and tighten bolt.




7. Install hinges to front of cushion and tighten with bolts. Check that lock properly engages.
8. Fold backrest onto cushion and overlap trunk mat and mat at rear of backrest.

CAUTION:
- Do not allow center seat belt to get under cushion when folding cushion.
- Ensure that side seat belt tongue is free from cushion and trim panel.
- Lift front of cushion to ensure that cushion is properly locked.





Torque specifications