A/T

DTC P0340 - CAMSHAFT POSITION SENSOR CIRCUIT MALFUNCTION

DTC DETECTING CONDITION:
- Immediately at fault recognition

TROUBLE SYMPTOM:
- Engine stalls.
- Failure of engine to start

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes.

Wiring Diagram:

WIRING DIAGRAM

11AD1: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.

1. Turn ignition switch to OFF.
2. Disconnect connector from camshaft position sensor.

Connector & Terminal - [(E15) No.1 - Engine Ground]:

3. Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance more than 100 K.Ohms?

YES: Repair harness and connector.

NOTE: In this case, repair the following:
- Open circuit in harness between camshaft position sensor and ECM connector
- Poor contact in ECM connector
- Poor contact in coupling connector (B21).

NO: Go to step 11AD2.

11AD2: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal - [(E15) No.1 - Engine Ground]:

Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance less than 10 Ohms?

YES: Repair ground short circuit in harness between camshaft position sensor and ECM connector.

NOTE:The harness between both connectors are shielded. Repair ground short circuit in harness together with shield.

NO: Go to step 11AD3.

11AD3: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal - [(E15) No.2 - Engine Ground]:

Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance less than 5 Ohms?

YES: Go to step 11AD4.

NO: Repair harness and connector.

NOTE: In this case, repair the following:
- Open circuit in harness between camshaft position sensor and ECM connector
- Poor contact in ECM connector
- Poor contact in coupling connector (B21)

11AD4: CHECK CONDITION OF CAMSHAFT POSITION SENSOR.

CHECK: Is the camshaft position sensor installation bolt tightened securely?

YES: Go to step 11AD5.

NO: Tighten camshaft position sensor installation bolt securely.

11AD5: CHECK CAMSHAFT POSITION SENSOR.

1. Remove camshaft position sensor.

Terminals [No.1 - No.2]:

2. Measure resistance between connector terminals of camshaft position sensor.

CHECK: Is the resistance between 1 and 4 K.Ohms?

YES: Repair poor contact in camshaft position sensor connector.

NO: Replace camshaft position sensor.