Operation CHARM: Car repair manuals for everyone.

A/T

DTC P0500 - VEHICLE SPEED SENSOR MALFUNCTION

DTC DETECTING CONDITION:
- Immediately at fault recognition

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes.

Wiring Diagram:





WIRING DIAGRAM

11AS1: CHECK DTC P0720 ON DISPLAY.

CHECK: Does the Subaru Select Monitor or OBD-II general scan tool indicate DTC P0720?

YES: Check vehicle speed sensor 2 signal circuit.

NO: Go to step 11AS2.

11AS2: CHECK SPEEDOMETER OPERATION IN COMBINATION METER.

CHECK: Does speedometer operate normally?

YES: Go to step 11AS3.

NO: Check speedometer and vehicle speed sensor.

11AS3: CHECK HARNESS BETWEEN ECM AND COMBINATION METER CONNECTOR.

1. Turn ignition switch to OFF.
2. Disconnect connector from combination meter.

Connector & Terminal - [(B135) No.24 - (i10) No.13]:





3. Measure resistance between ECM and combination meter.

CHECK: Is the resistance less than 10 Ohms?

YES: Repair poor contact in ECM connector.

NO: Repair harness and connector.

NOTE: In this case, repair the following:
- Open circuit in harness between ECM and combination meter connector
- Poor contact in ECM connector
- Poor contact in combination meter connector
- Poor contact in coupling connector (B36)