M/T

DTC P0500 - VEHICLE SPEED SENSOR MALFUNCTION

DTC DETECTING CONDITION:
- Immediately at fault recognition

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes.

Wiring Diagram:

WIRING DIAGRAM

10AT1: CHECK SPEEDOMETER OPERATION IN COMBINATION METER.

CHECK: Does speedometer operate normally?

YES: Go to step 10AT2.

NO: Check speedometer and vehicle speed sensor.

10AT2: CHECK HARNESS BETWEEN ECM AND COMBINATION METER CONNECTOR.

1. Turn ignition switch to OFF.
2. Disconnect connector from combination meter.

Connector & Terminal - (B135) No.24 - (I10) No.13]:

3. Measure resistance between ECM and combination meter.

CHECK: Is the resistance less than 10 Ohms?

YES: Repair poor contact in ECM connector.

NO: Repair harness and connector.

NOTE: In this case, repair the following:
- Open circuit in harness between ECM and combination meter connector
- Poor contact in ECM connector
- Poor contact in combination meter connector
- Poor contact in coupling connector (B36)