M/T

DTC P1100 - STARTER SWITCH CIRCUIT LOW INPUT

DTC DETECTING CONDITION:
- Two consecutive driving cycles with fault

TROUBLE SYMPTOM:
- Failure of engine to start

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes.





WIRING DIAGRAM

10BN1: CHECK OPERATION OF STARTER MOTOR.
Depress the clutch pedal.

CHECK: Does starter motor operate when ignition switch to "ST"?

YES: Repair harness and connector.

NOTE: In this case, repair the following:
- Open or ground short circuit in harness between ECM and starter motor connector.
- Poor contact in ECM connector.

NO: Check starter motor circuit.