Diagnostics Item 8 (6I)

611: CHECK HARNESS CONNECTOR BETWEEN REAR GATE LATCH SWITCH AND SECURITY CONTROL MODULE.
1. Disconnect connector from rear gate latch switch and security control module.

Connector & Terminal - [(D46) No.1 - (B93) No.4]:

2. Measure resistance between rear gate latch switch connector (D46) and security control module connector (B93).

CHECK: Is the resistance less than 10 Ohms?

YES: Go to step 612.

NO: Repair wiring harness between rear gate latch switch and security control module.

Connector & Terminal - [(D46) No.2 (+) - Chassis Ground (-)]:

612: CHECK HARNESS CONNECTOR BETWEEN REAR GATE LATCH SWITCH AND CHASSIS GROUND.
Measure resistance between rear gate latch switch connector (D46) and chassis ground.

CHECK: Is the resistance less than 10 Ohms?

YES: Go to step 613.

NO: Repair wiring harness between rear gate latch switch and chassis ground.

Terminals [No.1 - No.2]:

613: CHECK REAR GATE LATCH SWITCH.
Measure resistance between rear gate latch switch terminals.

CHECK: Is the resistance less than 10 Ohms?

YES: Go to step 614.

NO: Replace rear gate latch switch.

Terminals [No.1 - No.2]:

614: CHECK REAR GATE LATCH SWITCH.
Measure resistance between rear gate latch switch terminals while pushing the switch.

CHECK: Is the resistance less than 10 Ohms?

YES: Replace rear gate latch switch.

NO: Replace security control module.