Child Restraint: Service and Repair

REMOVAL AND INSTALLATION

RETRACTOR ASSEMBLY

Built-In Child Restraint:

WARNING: Replace the built-in child restraint equipped vehicle seat back assembly if the child restraint was in use during a serious collision. The built-in restraint may be severely weakened. In a subsequent accident, it might not be able to provide adequate protection. The entire assembly should be replaced even if damage is not obvious.

1. Detach mat and then remove nuts and screws from back panel (a).




2. Detach back panel while removing webbing of built-in child restraint.




3. Remove screws and then detach cushion board (a).




4. Remove screws and then detach retractor assembly (a).
5. Installation is in the reverse order of removal.