Removal and Installation

1. Remove battery cable holder (A) from battery rod.
2. Disconnect the positive (+) terminal after disconnecting the negative (-) terminal of battery.




3. Remove flange nuts from battery rods and take off battery holder.
4. Remove battery.
5. Installation is in the reverse order of removal.

Tightening torque:
3.4 ± 1.0 N.m (0.35 ± 0.1 kg.m, 2.5 ± 0.7 ft.lb)

NOTE:
- Clean battery cable terminals and apply grease to retard the formation of corrosion.
- Connect the positive (+) terminal of battery and then the negative (-) terminal of the battery.