Removal and Installation

REMOVAL
1. Remove wheel.
2. Remove axle nut.
3. Remove brake drum





4. Unscrew the brake pipe flare nut and disconnect brake pipe.
5. Remove hub.





6. Remove the bolts installing back plate, and then, remove brake assembly.





7. Remove the bolts installing wheel cylinder on back plate, and remove it.

INSTALLATION





1. Install wheel cylinder on back plate, and tighten bolts.





2. Install brake assembly on housing, and tighten bolts to install back orate.
3. Install hub.
4. Connect brake pipe, and tighten brake pipe flange nut.
Tightening torque:
14.7 Nm (1.5 kgf-m, 10.8 ft. lbs.)
5. Set the outside diameter of brake shoes less than 0.5 - 0.8 mm (0.020 - 0.031 inch) in comparison with the inside diameter of brake drum.
6. Install brake drum.
7. After installing brake assembly, bleed air from brake line.