Parking Brake System: Adjustments
ADJUSTMENTSHOE CLEARANCE
1. Remove adjusting hole cover from back plate.
2. Turn adjusting screw using a slot-type screw-driver until brake shoe is in close contact with disc rotor.
3. Turn back (downward) adjusting screw 3 or 4 notches.
4. Install adjusting hole cover to back plate.
LEVER STROKE
1. Remove console box lid.
2. Forcibly pull parking brake lever 3 to 5 times.
3. Adjust parking brake lever by turning adjusting nut until parking brake lever stroke is set at 7 to 8 notches with operating force of 196 N (20 kgf, 44 lbs.).
4. Tighten lock nut.
5. Install console box lid.
Lever stroke:
7 to 8 notches when pulled with a force of 196 N (20 kgf, 44 lbs.)
Tightening torque (Lock nut): 5.9 Nm (0.60 kgf-m, 4.3 ft. lbs.)