Cruise Control Command Switch

Cruise Control Command Switch

REMOVAL

CAUTION: Before starting operation carefully read the appropriate notes for proper handling of the airbag module.

1. Set front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect battery ground cable from battery and wait for at least 20 seconds before starting work.

4. Using TORX(R) BIT T30 (Tamper resistant type), remove two TORX(R) bolts which secure driver's air-bag module.
5. Disconnect airbag module connector on back of airbag module.

6. Remove horn switch from steering wheel as shown.

7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.

INSTALLATION
Install in the reverse order of removal.