Exterior Moulding / Trim: Service and Repair

PROTECTOR

REMOVAL

NOTE: Do not reuse protector.

1. Type A and B:
Protector is attached to body with clips. While holding end of protector by hand, force protector out.









2. Type C:
Protector is attached to body with clips. Remove door inner trim, and detach protector by pushing clip pawl from inside.

3. Type D:
Protector is attached to body with clips. While holding end of protector by hand, force protector out.






INSTALLATION

Install in the reverse order of removal.

NOTE:
- Type A: Insert clip pins into holes in body, then fit end cap buffers into place.
- Type B: Insert spin weld clips into holes in body, then fit bushings into place.
- Type C and D: Align the clips with holes in body and insert them.
- Install clips in standard holes first.