Speedometer Gear

A: REMOVAL
1. Remove the manual transmission assembly from vehicle.
2. Remove back-up light switch and neutral position switch.
3. Remove transfer case and extension case assembly.
4. Remove transmission case.





5. Remove outer snap ring and pull out speedometer driven gear. Next, remove vehicle speed sensor, oil seal, speedometer shaft and washer.

B: INSTALLATION
1. Install washer and speedometer shaft, and press fit oil seal with ST.

CAUTION: Use new oil seal, if it has been removed.

ST 899824100 or 499827000 PRESS
2. Install vehicle speed sensor.





3. Install speedometer driven gear and snap ring.

CAUTION: Use new snap ring, if it has been removed.

4. Install transmission case.
5. Install transfer case and extension case assembly.
6. Install back-up light switch and neutral position switch.
7. Install the manual transmission assembly to vehicle.

C: INSPECTION
Check the speedometer gear, oil seal and speedometer shaft for damage. Replace if damaged.