Air Bag: Service Precautions

CAUTION:




- The airbag module must not be disassembled. The airbag module cannot be used again once inflated.




- When removing and installing the airbag module, the operator should stand, as much as possible, on the side of the airbag module.




- After removal, the airbag module should be kept away from heat and light sources, and stored on a clean, flat surface to prevent from any damage to its lower structure.




- Do not check airbag module continuity with airbag removed from the vehicle body.
- Replace airbag module with a new one, should any of the following conditions develop:
- Pad surface is scratched or cracked.
- Connector harness is damaged.
- Inflator side structure of module is cracked or deformed.
- Module is excessively stained with water, oil, etc.
- Module was accidentally dropped.




- When storing a removed airbag module, be sure to place it in parallel with floor with the pad facing up. Do not place it against a wall, or place anything on the pad; otherwise, a dangerous condition may be created if the module malfunctions.