Driver's Airbag Module

REMOVAL
1. Position front wheels straight ahead. (After moving a vehicle more than 5 m (16 ft) with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead).
2. Turn ignition switch OFF.
3. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.




4. Using TORX(R) BIT T30, remove two TORX(R) bolts on side of steering wheel.




5. Disconnect airbag connector on back of airbag module, and then remove airbag module.
6. Refer to "CAUTION" for handling of a removed airbag module.

INSTALLATION
1. Install in the reverse order of removal.

CAUTION: Do not allow harness and connectors to interfere or get tangled up with other parts.