Rear Cross-Member: Service and Repair

REMOVAL
1. Separate front exhaust pipe and rear exhaust pipe.
2. Remove rear exhaust pipe and muffler.
3. Remove rear differential.
4. Disconnect link front from sub frame.
5. Disconnect link rear from sub frame.
6. Disconnect link upper from sub frame.





7. Place transmission jack under sub frame.
8. After removing bolts, remove sub frame and support sub frame from vehicle body.

INSTALLATION
1. Install in reverse order of removal.
2. For installation and tightening torque of rear differential.





3. Using transmission jack, support rear arm horizontally and tighten nuts and bolts securing rear arm, link front, link rear, link upper and shock absorber.

NOTE: Check wheel alignment and adjust if necessary.

INSPECTION
Check removed parts for wear, damage and cracks, and correct or replace if defective.