Front
The content of this article/image reflects the changes Identified inTSB # 18-101-06
as of 02/13/2006
and applies to 2002 Legacy, Forester & Impreza Models
REMOVAL
1. Loosen wheel nuts, jack-up vehicle, support it with safety stands, and remove wheel.
2. Remove caliper body from housing, and suspend it from strut using a wire.
3. Remove the disc rotor.
NOTE: If disc rotor seizes up within the hub, drive disc rotor out by installing an 8-mm bolt in holes B on the rotor.
4. Clean mud and foreign particles from caliper body assembly and support.
INSTALLATION
1. Install the disc rotor.
2. Install the caliper body to housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)