Transmission Position Sensor/Switch: Service and Repair

REMOVAL

1. Set up the vehicle on the lift.
2. Move select lever to neutral position.
3. Remove air cleaner case.





4. Disconnect inhibitor switch connector.
5. Remove inhibitor switch connector from stay.
6. Lift-up the vehicle.
7. Remove front exhaust pipe with center exhaust pipe.





8. Remove snap pin from range select lever.





9. Remove plate assembly from transmission case.





10. Remove bolts.





11. Move range select lever to parking position (left side).





12. Remove inhibitor switch from transmission.
13. Disconnect inhibitor switch harness from inhibitor switch.

INSTALLATION

1. Connect inhibitor switch harness to inhibitor switch.





2. Install inhibitor switch to transmission case.
3. Move range select lever to neutral position.





4. Using ST, tighten bolts of inhibitor switch.
ST 499267300 STOPPER PIN
Tightening torque: 3.4 Nm (0.35 kgf-m, 2.5 ft. lbs.)
5. Install select cable to range select lever.





6. Install plate assembly to transmission.
Tightening torque:
T: 24.5 Nm (2.50 kgf-m, 18.1 ft. lbs.)





7. Install snap pin to range select lever.
8. Install front exhaust pipe with center exhaust pipe.
9. Lower the vehicle.
10. Install inhibitor switch connector from stay.





11. Connect inhibitor switch connector.
12. Install air cleaner case.
13. Inspect inhibitor switch.