Air Bag Control Module: Service and Repair
Airbag Control ModuleCAUTION: Do not disassemble the airbag control module.
If the airbag control module is deformed or if water damage is suspected, replace the airbag control module with a new genuine part.
Do not drop the airbag control module.
After removal, keep the airbag control module on a dry, clean surface away from moisture, heat, and dust.
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect ground cable from battery, and wait for at least 20 seconds before starting work.
3. Remove console box.
4. Disconnect the airbag control module connector.
5. Using T408 TORX bit (Tamper resistant type), remove four TORX' bolts in the order shown in the figure.
INSTALLATION
CAUTION: Use new TORX bolts during installation.
Install in the reverse order of removal.