Rear

INSPECTION
1. ABS SENSOR
1. Check pole piece of ABS sensor for foreign particles or damage. If necessary, clean pole piece or replace ABS sensor.





1 of 2





2 of 2

2. Measure ABS sensor resistance.

CAUTION: If resistance is outside the standard value, replace ABS sensor with new one.

NOTE: Check ABS sensor cable for discontinuity. If necessary, replace with a new one.

2. SENSOR GAP





Clearances (sensor gaps) should be measured one by one to ensure tone wheel and speed sensor are installed correctly.
ABS sensor clearance: 0.7 - 1.2 mm (0.028 - 0.047 inch)

NOTE:
^ If clearance is narrow, adjust by using a spacer (Part No. 26755AAOOO).
^ If clearance is wide, check the outputted voltage then replace ABS sensor or tone wheel if the outputted voltage is outside the specification.

3. OUTPUT VOLTAGE





Output voltage can be checked by the following method. Install resistor and condenser, then rotate wheel about 2.75 km/h (2 MPH) or equivalent.

NOTE: Regarding terminal No., refer to item 1. ABS SENSOR.

ADJUSTMENT
Adjust the gap using spacer (Part No. 26755AA000).