Without Scan Tool
6. Subaru Select MonitorA: OPERATION
3. CLEAR MEMORY MODE
1) On the Main Menus display screen, select the {2. Each System Check} and press the [YES] key.
2) On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
3) Press the [YES] key after displayed the information of transmission type.
4) On the Transmission Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5) When the 'Done' end 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
9. Clear Memory Mode
A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
Current trouble codes shown on the display are cleared by turning the ignition switch OFF after conducting on-board diagnostics operation. Previous trouble codes, however, cannot be cleared since they are stored in the TCM memory, which is operating on the back-up power supply. These trouble codes, can be cleared by removing the specified fuse (located under the right or left lower position of the instrument panel).
CLEAR MEMORY: Removal of No. 4 fuse (for at least one minute)
^ The No. 4 fuse is located in the line to the memory back-up power supply of the TCM. Removal of this fuse clears the previous Diagnostic Trouble Codes (DTC) stored in the TCM memory.
^ Be sure to remove the No. 4 fuse for at least the specified length of time. Otherwise, Diagnostic Trouble Codes (DTC) may not be cleared.
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to clear Diagnostic Trouble Codes (DTC).