Without Scan Tool
6. Subaru Select MonitorA: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
1) Prepare Subaru Select Monitor kit.
2) Connect diagnosis cable to Subaru Select Monitor.
3) Insert cartridge into Subaru Select Monitor.
4) Connect Subaru Select Monitor to data link connector.
1) Data link connector located in the lower portion of the instrument panel (on the driver's side).
2) Connect diagnosis cable to data link connector.
CAUTION: Do not connect scan tools except for Subaru Select Monitor and OBD-II general scan tool.
5) Turn ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6) On the Main Menus display screen, select the {Each System Check} and press the [YES] key.
7) On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
8) Press the [YES] key after displayed the information of transmission type.
9) On the Transmission Diagnosis display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
10) On the Diagnostic Code(s) Displays display screen, select the {Latest Diagnostic Code(s)} or {Memorized Diagnostic Code(s)} and press the [YES] key.
NOTE:
^ For detailed concerning diagnostic trouble codes, refer to the DIAGNOSTIC TROUBLE CODE LIST.
2. READ CURRENT DATA
1) On the Main Menus display screen, select the {Each System Check} and press the [YES] key.
2) On the System Selection Menus display screen, select the {Transmission Control System} and press the [YES] key.
3) Press the [YES] key after displayed the information of transmission type.
4) On the Transmission Diagnosis display screen, select the {Current Data Display & Save} and press the [YES] key.
5) On the Data Display Menus display screen, select the {Data Display} and press the [YES] key.
6) Using the scroll key, move the display screen up or down until the desired data is shown.
^ A list of the support data is shown in the following table.
7. Read Diagnostic Trouble Code (DTC)
A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
The AT OIL TEMP warning light flashes the code corresponding to the faulty part.
The long segment (1.2 sec on) indicates a "ten", and the short segment (0.2 sec on) signifies a "one".
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to obtain and understand trouble codes.
8. Inspection Mode
A: OPERATION
Raise the vehicle using a garage jack and place on safety stands or drive the vehicle onto free rollers.
WARNING:
^ Before raising the vehicle, ensure parking brakes are applied.
^ Do not use a pantograph jack in place of a safety stand.
^ Secure a rope or wire to the front and rear towing or tie-down hooks to prevent the lateral runout of front wheels.
^ Do not abruptly depress/release clutch pedal or accelerator pedal during works even when engine is operating at low speeds since this may cause vehicle to jump off free rollers.
^ In order to prevent the vehicle from slipping due to vibration, do not place any wooden blocks or similar items between the safety stands and the vehicle.
^ Since the rear wheels will also rotate, do not place anything near them. Also, make sure that nobody goes in front of the vehicle.