Throttle Position Sensor/Switch: Service and Repair

A: REMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Disconnect the connector battery ground terminal.
2. Remove the air intake duct and cleaner case. (Non-turbo model)
3. Remove the intercooler (Turbo model).
4. Disconnect the connector back-up light switch and neutral position switch.





^ Non-turbo model





^ Turbo model
5. Lift-up the vehicle.





6. Remove the back-up light switch and neutral position switch with harness.

B: INSTALLATION





1. BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1. Install the back-up light switch and neutral position switch with harness.
Tightening torque: 24.5 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
2. Connect the connector of back-up light switch and neutral position switch.
3. Install the air intake duct and cleaner case. (Non turbo model)
4. Install the intercooler. (Turbo model)
5. Connect the battery ground terminal.