Removal and Installation
A: REMOVAL1. Set the vehicle on the lift.
2. Remove the gear shift knob.
3. Disconnect the ground terminal from battery.
4. Remove the console box.
5. Remove the boot plate from body.
6. Lift-up the vehicle.
7. Remove the rear exhaust pipe and muffler.
8. Remove the heat shield cover. (If equipped)
9. Remove the stay from transmission bracket.
10. Remove the rod from joint.
11. Remove the cushion rubber from body.
12. Remove the joint and then extract the spring pin.
13. Lower the vehicle.
14. Remove the gear shift lever.
B: INSTALLATION
1. Install the joint to the transmission and secure with the straight pin.
2. Insert the gear shift lever from room side.
NOTE: After inserting the rod and stay, temporarily put them onto transmission mount.
3. Lift-up the vehicle.
4. Install the joint to shifter arm.
5. Insert the spring pin.
6. Mount the cushion rubber on the body.
Tightening torque: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
7. Connect the rod to the joint.
Tightening torque: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
8. Connect the stay to transmission bracket.
Tightening torque: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
9. Install the heat shield cover. (If equipped)
10. Install the rear exhaust pipe and muffler.
11. Lower the vehicle.
12. Install the boot plate to body.
Tightening torque: 7.5 Nm (0.76 kgf-cm, 5.5 ft. lbs.)
13. Install the console box.