Cruise Cancel Conditions Diagnosis

1. Prepare Subaru Select Monitor kit.
2. Connect the diagnosis cable to the Subaru Select Monitor.




3. Insert the cartridge into the Subaru Select Monitor
4. Connect the Subaru Select Monitor to the data link connector.




1. Data link connector located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to the data link connector.

5. Start the engine and turn the cruise control main switch to ON.




6. Turn the Subaru Select Monitor switch to ON.
7. On the Main Menu display screen, select the (All System Diagnosis) and press the [YES] key.

NOTE: The diagnostic trouble code is also shown in the (Each System Check) mode. This mode is called up on the Cruise Control Diagnosis screen by selecting the item (Cancel Code(s) Display).

8. Drive vehicle at least 30 km/h (19 mph) with cruise speed set.
9. If the cruise speed is canceled itself (without doing any cancel operations), a diagnostic trouble code will appear on select monitor display.

CAUTION:
- A diagnostic trouble code will also appear when cruise cancel is effected by driver. Do not confuse.
- Have a co-worker ride in vehicle to assist in diagnosis during driving.

NOTE: Diagnostic trouble code will be cleared by turning ignition switch or cruise control main switch to OFF.