Front

REMOVAL
1) Disconnect the ground terminal from battery.
2) Jack-up the vehicle, support it with rigid racks, and remove the wheel.
3) Disconnect the front ABS sensor connector located next to the front strut mounting house in engine compartment.





4) Remove the bolts which secure sensor harness to strut.





5) Remove the bolts which secure sensor harness to body.
6) Remove the bolts which secure front ABS sensor to housing, and remove the front ABS sensor.





CAUTION:
^ Be careful not to damage the pole piece located at tip of the sensor and teeth faces during removal.
^ Do not pull the sensor harness during removal.

INSTALLATION





1) Temporarily install the front ABS sensor on housing.

CAUTION: Be careful not to strike the ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.





2) Install the front ABS sensor on strut and wheel apron bracket.
Tightening torque: 32 Nm (3.3 kgf-m, 24 ft. lbs.)
3) Place a thickness gauge between the ABS sensor's and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten the ABS sensor on housing to specified torque.
ABS sensor standard clearance: 0.3 - 0.8 mm (0.012 - 0.031 inches)
Tightening torque: 32 Nm (3.3 kgf-m, 24 ft. lbs.)

CAUTION: Check the marks on the harness to make sure that no distortion exists.
RH: White
LH: Yellow

NOTE: If the clearance is outside specifications, readjust.

4) After confirmation of the ABS sensor clearance, connect the connector to ABS sensor.
5) Install the wheel.
6) Connect the battery ground terminal to battery.