Cruise Control Switch: Service and Repair

Cruise Control Main Switch

REMOVAL
1. Disconnect the ground terminal from battery.
2. Remove the screws and clip from the instrument panel lower cover.




3. Remove the instrument panel lower cover.




4. Disconnect the connector from the cruise control main switch(A).




5. Remove the main switch by pushing it outward.

INSTALLATION
Install is in the reverse order of removal.

Cruise Control Command Switch

REMOVAL

WARNING: Before servicing, be sure to read the notes in the AB section for proper handling of the driver's airbag module.

1. Set the front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect the ground terminal from battery and wait for at least 20 seconds before starting work.




4. Using TORX(R) BIT T30 (Tamper resistant type), loosen two TORX(R) bolts which secure driver's air-bag module.
5. Disconnect the airbag module connector on back of the airbag module.




6. Remove the horn switch from the steering wheel as shown.




7. Disconnect the horn and cruise control command switch connector, then remove the cruise control command switch.

INSTALLATION
Install is in the reverse order of removal.