Oil Pressure Sender: Service and Repair
REMOVAL1. Remove the generator from bracket.
^ Non-Turbo model
^ Turbo model
1. Disconnect the connector and terminal from generator.
^ Non-Turbo model
^ Turbo model
2. Remove the V-belt cover.
3. Remove the front side V-belt.
4. Remove the bolts which install generator on bracket.
2. Disconnect the terminal from oil pressure switch.
3. Remove the oil pressure switch.
INSTALLATION
1. Apply fluid packing to oil pressure switch threads.
Fluid packing: THREE BOND 1215 or equivalent
2. Install the oil pressure switch onto engine block.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
3. Connect the terminal of oil pressure switch.
4. Install the generator on bracket and temporarily tighten installing bolts.
5. Install the front side V-belt and adjust it.
^ Non-Turbo model
^ Turbo model
6. Install the V-belt cover.
^ Non-Turbo model
^ Turbo model
7. Connect the connector and terminal to generator.